first small shoping at this year...
side lists deicated for painting, present ones are terrible and too soft for paint so after instaling that stuff look terrible and black interior light for black roof and i brought srews for flywheel and basket for fuel filter dedicated for VR6 because next friday im going to buy new engine 1.8t from Audi S3 with 210 horses








my new engine







so i started my first SWAP
it was little bit tuff and that is not so easy like i thought before but i did this part pretty well,











that is not the and
but right know i need to prepare 1.8T for instalig in my mk3, first of all i will change all parts which need to be replaced

i found some time to clean engine bay, and i found some rost ****, but its not that bad i think couple hours and i will remove this
any way i need to do some small clean look in engine bay and of course i need to paint it up

i did only half of it because i spend most of m time for cleaning the gear box and i think i did that pretty good to compare i made some pics
BEFORE


DURING the cleaning


AFTER





I fit in the gearbox(gearbox from tdi engine ) with engine and of course it fits




and i figure out first problem turbo's oli flow is instaled in wrong place i need to modificate this part becaus the right engine mount will not fit to original place, besides that i try to fit engine mount to the place and its great... it fits


I clean completly half of the engine bay for coat and lack, i think in 2 weeks car will go for new paint in engine bay, of corse paint will be thee same as on car LC5M Moonlightblue




****t. rost i think i made it pretty good...


and here from wheel side

__________________
Best Regards
Chris

ONLY REAL MEN KNOWS HOW TO DRIVE DEEP AIRLESS