I feel a bad thing coming...

[TwinScrew20v]

Well...My motor wasnt all that happy when I tore it down. So I figure Id use my spare G60 block and rebuild it right??? Wrong...A sacrificial G-Lader decided that that block needed some Damage too. So I go hunting for another G60 or PL 16v block...No dice :frown: Well I DID find a set of 82.5mm pistons for a 20v...AND a FREE 9A 2.0 16v block. Can anyone see where this is goin??? :biggrin:

[MelG60]

2.0 20V! Are those pistons for 20mm wrist pins?

[TwinScrew20v]

Ive found both 20mm and 19mm for 8.5:1, 9.25:1, 9.5, 13:1 compression ratios. JE and Weisco seem to have both sizes off the shelf in 82mm and 82.5mm and prints for 81, 81.5, 83, and 84mm pistons. So Im not complainin :biggrin: Im most likely going to be using the 20mm pistons if I get the 2.0 block...But Ill stick with the 19mm rods I have if thats how it goes.